Yamaha DT125RE 2005 Service Manual page 56

ADJUSTING THE CLUTCH CABLE FREE PLAY
1
2
3
1
1
NOTE:
• When installing the crankcase cover, engage
the autolube pump drive gear with its driven
gear as slowly turn the autolube pump shaft.
• Tighten the screws (Crankcase cover) in
stage, using a crisscross pattern.
• Before installing the brake pedal apply the
lithium soap base grease to the brake pedal
pivot shaft.
12. Install:
• Gasket (Autolube pump cover)
13. Connect:
• Autolube pump hoses
• Autolube pump cable
14. Install:
• Screw (Water outlet pipe)
Screw (Water outlet Pipe)
8 Nm (0,8 m • kg, 5,8 ft • lb)
15. Connect:
• Outlet hose (Radiator)
16. Adjust:
• Clutch cable free play
Refer to the "Cable free play adjustment"
section."
17. Install:
• Brush guard
18. Fill:
• Crankcase
Refer to the "TRANSMISSION OIL REPLA-
CEMENT" section.
Recommended oil:
SAE10W30 Type SE Motor Oil
Periodic Oil Change
0,75 L
19. Fill:
• Radiator
• Reservoir tank (radiator)
Refer to the "COOLANT REPLACEMENT"
section.
Total amount:
0,92 L
3-15
CHK
ADJ