Yamaha DT125RE 2005 Service Manual page 117

ASSEMBLING AND INSTALLING THE FRONT AND
3
REAR BRAKE CALIPER
8. Install:
• Copper washers
• Brake hose
• Union bolt
2
3
1
CAUTION
When installing the brake hoses to the cali-
per
the brake pipe with the projections
them.
s WARNING
s
• Proper hose routing is essential to insu-
re safe machine operation. Refer to
"CABLE ROUTING"
• Always use new copper washers.
9. Fill:
• Master cylinder tank
CAUTION
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
s WARNING
s
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage
and poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful che-
mical reaction, leading to poor brake
performance.
• When refilling, be careful that water does
not enter the brake master cylinder
reservoir. Water will significantly lower
the boiling point of the brake fluid and
could cause vapor lock.
4-29
CHAS
Union bolt:
26 Nm (2.6m•kg, 19ft•lb)
and master cylinder
Recommended brake fluid:
DOT 4
lightly touch
on