Yamaha DT125RE 2005 Service Manual page 212

ENGINE ASSEMBLY AND ADJUSTMENTS
3
2
4
2
3
1
11. Install:
• Friction plates
• Clutch plates
1 • Clutch damper
Installation steps
• Install the friction plate onto the clutch
boss.
• Install the clutch plate so as to locate the
projection
• Install the friction plate with the larger insi-
de diameter onto the clutch boss.
• Install the clutch damper onto the clutch
plate.
• Install the remaining clutch plates and fric-
tion plates alternately on the clutch boss.
• Be sure to install a clutch plate with pro-
jection offset aproximately 60º from pre-
vious plate projection.
Continue this procedure in a clockwise
direction until all clutch plates are installed.
NOTE:
Before installing friction and clutch plates, sink
them into transmission oil almost 3 hours
before mounting
12. Install:
• Push rod #1
• Pressure plate
• Clutch springs
• Bolts (Pressure plate)
NOTE:
Align the punched mark
with the punched mark
sure plate.
13. Tighten:
• Bolts (Pressure plate)
5-50
ENG
at #1.
on the clutch boss
on the clutch pres-
Bolt (Pressure plate):
6 Nm (0.6 m•kg; 4.8 ft•lb)