Yamaha DT125RE 2005 Service Manual page 103

REPLACING THE FRONT BRAKE PADS/
FRONT
a
REPLACING THE REAR BRAKE PADS
1
6. Lubricate:
• retaining bolt
Recommended lubricant
Lithium-soap-based grease
CAUTION
• Do not allow grease to contact the brake
pads.
• Remove any excess grease.
7. Install:
• retaining bolt
8. Check:
• brake fluid level
Below the minimum level mark k a
the recommended brake fluid to the proper
level.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" in chapter 3.
9. Check:
• brake lever operation
Soft or spongy feeling
system.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" in chapter 3.
EAS00583
REPLACING THE REAR BRAKE PADS
NOTE:
When replacing the brake pads, it is not
necessary to disconnect the brake hose or
disassemble the brake caliper.
4-15
CHAS
18 Nm (1,8 m•kg, 13ft•lb)
Add
Bleed the brake