Yamaha DT125RE 2005 Service Manual page 38

CABLE ROUTING
Front brake hose
Clutch wire
Ignition coil
Throttle wire
Therm switch
Sidestand switch wire lead
Oil hose
A
D
E
C
F
H
G
L
CABLE ROUTING
A Route brake hose through the guide.
B Clamp clutch wire.
C Guide wire (chassis): SW handle wire lead
(R), SW handle wire lead (L), clutch SW
wire lead, front stop SW wire lead, wire
throttle, wire clutch.
D Insert installation clip to frame hole.
E Route clutch wire through the guides.
F Connect ground on the front part of the
coil. Install screw and wire terminal.
G Cover thermo-switch with cap.
H Insert connector to frame clamp (X3).
I Install clamp with open part to the upper
side. Route pipe overflow and pipe I
through clamp.
J Route sidestand switch through brackets.
The lead must have no slack at distance
"X".
K Route oil hose through clamp under the
battery.
L Route sidestand switch through the lower
part of the air filter.
I
B
K
J
x
2-19
SPEC