Mounting The Automatic Spray Guns - Krautzberger RA 5 Operating Instruction

5.3

Mounting the automatic spray guns

Changing the installation position of the spray gun
To change the installation position of the spray gun, the retaining bolt ( Fig. 4/2) can be
screwed into the adapter ( Fig. 4/1) from the other side (tightening torque: see
'Technical data' on page 44).
Fig. 4: Mounting the automatic spray guns
1. Fasten the adapter ( Fig. 4/1) with the retaining bolts ( Fig. 4/2) to a suitable construction.
2. The main element is either plugged in (
screwed on (
GB–18
Operating instructions
Ä Chapter 5.4.2 'Screw-type design' on page 20) depending on the design.
Ä Chapter 5.4.1 'Plugged-in design' on page 19) or
mail@krautzberger.com, www.krautzberger.com
T-Dok-449-GB-Rev.4
Ä Chapter 12