Hand-held Spray Gun KS 5F
7.4
Clean hand-held spray gun
WARNING!
Risk of injury due to improper cleaning!
–
Adhere to the safety data sheets of the cleaning product manufacturer.
–
Do not fully immerse the hand-held spray gun in a cleaning product.
1.
Disrupt the spraying process by releasing the pull lever.
2.
Close the material supply and switch off the fluid pressure pump if necessary.
3.
Release the residual energy by activating the pull lever.
4.
Establish the cleaning product supply at the fluid connection.
5.
If necessary, switch on the fluid pressure pump for the cleaning medium.
6.
WARNING!
Risk of injury due to recoil forces during the activation of the hand-held spray
gun!
Start spraying process by activating the pull lever.
7.
Spray until the cleaning product runs clear.
8.
End the spraying process by releasing the pull lever.
9.
End the supply of the cleaning product, switch off the fluid pressure pump if necessary.
10.
Release the residual energy by activating the pull lever and blow out the cleaning material
residue.
11.
Take preventative measures against unintended operation or triggering of the pull lever by
flipping the locking lever.
12.
Clean the outside of the hand-held spray gun with a cloth soaked in cleaning product.
7.5
Replace threaded needle and needle pack
General Information about the replacement of parts
n
Slightly grease sliding parts with special Krautzberger grease.
The special grease can be purchased from Krautzberger GmbH (contact data see last page).
■ 200-0380
ENGLISH
GB–25