Table of Contents
Advertisement
Automatic spray gun A15 eco
5 Installation
Personnel:
n
Qualified personnel
Protective equipment:
n
Protective clothing
n
Safety goggles
n
Safety shoes
n
Protective gloves
5.1
General installation information
Adhere to the following general information for the installation:
n
Only carry out the installation and start-up in accordance with the steps described in these
operating instructions.
n
Ensure that the utilised hose lines meet the requirements for pressure, chemical and mechan-
ical loads.
n
Only operate the automatic spray gun after proper fastening on a suitable carrier design.
n
Make sure that the connected compressed air is oil-free and free of solid matter.
n
Operate the automatic spray gun with processed, dried compressed air (air quality pursuant to
DIN ISO 8573-1: quality class 4).
n
Vibration and recoil forces may occur on the automatic spray gun during operation. Ensure
sufficient fastening.
n
Never point the compressed air at living beings.
5.2
Mounting automatic spray gun
Fig. 2: Mounting automatic spray gun
1.
Slide the spray gun with the fastening hole ( Fig. 2/2) over an on-site retaining bolt (Æ = 12
mm).
2.
Fasten the spray gun with the screws ( Fig. 2/1).
3.
Ensure proper earth connection of the automatic spray gun.
200-0383
ENGLISH
GB–17
Advertisement
Table of Contents
