Checking The Configuration - Huawei AR150 Series Configuration Manual

Huawei AR150&200&1200&2200&3200 Series Enterprise
Routers
Configuration Guide - Device Management
----End

5.5.1.3 Checking the Configuration

Prerequisites
All configurations of basic NTP functions are completed.
Procedure
l
l
l
----End
Issue 05 (2014-01-16)
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface for receiving NTP manycast packets is specified, and the interface view
is displayed.
3. Run:
ntp-service manycast-server [ ip-address | ipv6 [ ipv6-address ] ]
The local router is configured as the NTP manycast server.
Configure the NTP manycast client.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface for sending NTP manycast packets is specified, and the interface view
is displayed.
3. Run:
ntp-service manycast-client [ ip-address | ipv6 [ ipv6-address ] ]
[ authentication-keyid key-id | ttl ttl-number ]
The local router is configured as the NTP manycast client.
To specify the parameter authentication-keyid, see
NTP Authentication.
Run the display ntp-service status command to check the NTP service status.
Run the display ntp-service sessions [ verbose ] command to check the
NTP session status.
Run the display ntp-service trace command to check the path of reference
clock source from the local device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NTP Configuration
*
5.5.4.5 Configuring
105