Optional) Configuring The Lldp Power Capacity Negotiation - Huawei AR150 Series Configuration Manual

Huawei AR150&200&1200&2200&3200 Series Enterprise
Routers
Configuration Guide - Device Management
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
poe enable
The PoE function is enabled on the interface.
By default, the PoE function is enabled on the interfaces.
----End

6.6.2 (Optional) Configuring the LLDP Power Capacity Negotiation

Context
You can configure the TLV in LLDP so that the device can classify PDs through the LLDP
function enabled on the device . The device that is not configured with the LLDP function detects
and classifies PDs through analyzing current and resistance between the device and PDs.
Compared with current and resistance analysis, the LLDP function provides a more
comprehensive and accurate analysis.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
lldp enable
LLDP is enabled globally.
By default, LLDP is disabled globally.
Step 3 Run:
interface interface-type interface-number
The interface view is displayed.
Step 4 Run:
lldp enable
LLDP is enabled on an interface.
If LLDP is enabled globally, by default, LLDP is enabled on each interface.
Step 5 Run:
lldp tlv-enable dot3-tlv power
LLDP is configured to advertise Power Via MDI TLV.
Issue 05 (2014-01-16) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 PoE Configuration
136