Huawei AR150 Series Configuration Manual page 113

Huawei AR150&200&1200&2200&3200 Series Enterprise
Routers
Configuration Guide - Device Management
l
l
Issue 05 (2014-01-16)
The interface for receiving NTP broadcast packets is specified, and the interface view
is displayed.
3. Run:
ntp-service broadcast-client
The local router is configured as the NTP broadcast client.
Multicast Mode
NOTE
Only after the clock of the multicast server is synchronized, the multicast client can be synchronized
with the multicast server.
Currently a maximum of 1024 multicast clients can be configured, but a maximum of 128 multicast
clients can work simultaneously.
Configure the NTP multicast server.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface for sending NTP multicast packets is specified, and the interface view
is displayed.
3. Run:
–
ntp-service multicast-server [ ip-address ] [ version number |
authentication-keyid key-id | ttl ttl-number ]
The local router is configured as the NTP multicast server on an IPv4 network.
–
ntp-service multicast-server [ ipv6 [ ipv6-address
[ authentication-keyid key-id | ttl ttl-number ]
The local router is configured as the NTP multicast server on an IPv6 network.
To specify the parameter authentication-keyid, see
NTP Authentication.
Configure the NTP multicast client.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface for receiving NTP multicast packets is specified, and the interface view
is displayed.
3. Run:
ntp-service multicast-client [ ip-address | ipv6 [ ipv6-address
The local router is configured as the NTP multicast client.
Manycast Mode
Configure the NTP manycast server.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 NTP Configuration
*
] ]
*
5.5.4.5 Configuring
] ]
104