Huawei AR150 Series Configuration Manual page 112

Huawei AR150&200&1200&2200&3200 Series Enterprise
Routers
Configuration Guide - Device Management
l
Issue 05 (2014-01-16)
1. Run:
system-view
The system view is displayed.
2. Run:
–
ntp-service unicast-peer ip-address [ version number | authentication-
keyid key-id |
interface interface-type interface-number | vpn-instance vpn-instance-
name | preference ]
The NTP peer with a specified IPv4 address is configured.
–
ntp-service unicast-peer ipv6 ipv6-address [ authentication-keyid key-
id | maxpoll max-number | minpoll min-number | source-interface
interface-type interface-number | vpn-instance vpn-instance-name |
*
preference ]
The NTP peer with a specified IPv6 address is configured.
The value of ip-address or ipv6-address must be a unicast address, and
cannot be a broadcast address, a multicast address or the IP address of the local clock.
To specify the parameter authentication-keyid, see
NTP Authentication.
Broadcast Mode
NOTE
The broadcast mode can be used only on a local area network (LAN).
Only after the clock of the broadcast server is synchronized, the broadcast client can be synchronized
with the broadcast server.
Configure the NTP broadcast server.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface for sending NTP broadcast packets is specified, and the interface view
is displayed.
3. Run:
ntp-service broadcast-server [ version number | authentication-keyid key-
*
id ]
The local router is configured as the NTP broadcast server.
To specify the parameter authentication-keyid, see
NTP Authentication.
Configure the NTP broadcast client.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
maxpoll max-number | minpoll min-number | source-
*
5 NTP Configuration
5.5.4.5 Configuring
5.5.4.5 Configuring
103