New Holland TS-100A Assembly & Instruction Manual page 60

Optional Lexan RH Door Kit Installation
New Holland "TS" Series Optional Door Kit No. 02980888
9.
Insert Handle into door from bottom, make
certain item 3 tube spacer is inserted through hole of
door and through hole of pipe brace, there is a rubber
pad to reinstall between pipe brace plate at upper
latch and door (See Figure 6) Install item 3 Nut onto
handle, Note when disassembled there was a large
flat washer here. The flat washer WILL NOT be used
in reassembly. Snug the item 3 nut but DO NOT
tighten.
10.
Lifting the Latch and turning to the correct
angle slide the latch actuated rod through the hole on
the latch. Turn and lower latch in place. Using the
original Bolts, Washers and nuts bolt on the latch to
pipe brace (See Figure 7). These can be tightened at
this time.
11.
Prepare the Door Hinges which are still on
tractor (See Figure 8) by making certain the round
rubber washers are in place, the ID of washer will
have the shoulder of the hinge sticking through it as
shown (See Large Rubber Washers Figure 8). The
lower hinge uses a two hole oblong rubber pad
between door and pipe brace.
12.
Install new door, make certain all rubber
pads are in place, Holding door push the lower hinge
up to door. Install the new 5/16" NC X 1-3/4" Gr. 5
Bolts P/N 00021900 from kit, Use the old small OD
structural flatwashers that were removed from origi-
nal door. The Top Hinge on the inside will have a
round rubber washer pad and a large round steel
washer. The lower hinge should have the oblong
rubber pad with two holes in it. Put the New 5/16" NC
locknuts with any washers that were remove form
original door. While supporting the door (see Figure
9) tighten the hinge mounting bolts, Do this slowly
and carefully making certain the shoulder oh hinge
goes through hole in door. DO NOT over tight these
bolts. Tighten the other fasteners on the door brace
and latch handle. If Door is not fitting right the door
striker bolt on the inner cab frame is adjustable by
loosing it up and moving it in or out as needed. USE
CAUTION when cleaning the Lexan door, DO NOT
use any cleaner that is harmful to plastic, Read all
directions for cleaner use befor using it, if using it for
the first time on the Lexan door, test it in a small out
of the way place. DO NOT use rough material such
as paper towels to clean Lexan Door.
Maverick (NH TS-100A,115A , 125A, 135A Asy.Man) 01/05
© 2005 Alamo Group Inc.
Latch Retaining
Bolt, Washer &
Nut
Inner Rubber Pad
Figure 7
Large Rubber
Washers
Lower Hinge
Figure 8
Figure 9
Section 6 - 4
Latch
Inner
Latch
Actuater
Rod
3
Large Rubber
Washers
Upper Hinge
1
5
2
3
4