New Holland TS-100A Assembly & Instruction Manual page 63

Installing Wheel Weight
1.
This Wheel Weight is 1400
lbs. Always use caution when
working with it.
2.
Locate the three Holes in
LH Rear Wheel. Make sure these
holes are 15/16" dia. if not, they
must be reamed out.
3.
Lift Left Rear Tractor
Wheel till it just clears the ground.
This will allow the Wheel to be
rotated when aligning mounting
holes for Weight.
4.
Using a forklift, lift Wheel
Weight into Wheel. When Wheel
Weight is centered in Wheel Se-
cure Forklift and Set Parking Brake
on Forklift. Insert one of the three
bolts through Weight and Wheel
(Rotate Wheel to align holes if
needed). Install a Hex Lock Nut on
inside. Insert the other two Bolts
through Weight and Wheel and
start the other two Locknuts. Do
not tighten yet. (See Figure 2)
5.
Looking at the outside
make sure the three special Wash-
ers (Figure 1 Item 2) are aligned
with the Slots in the Wheel Weight.
Tighten the three Bolts now. You
will need an assistant to hold the
other Side while you are tightening
the Bolts. While tightening Bolts,
check to make sure the three spe-
cial washers are seated correctly.
If these Bolts are tightened and
washer are not seated into the
recess on Wheel Weight, dam-
age will occur. (See Figure 3)
6.
Remove forklift away from
Wheel and Weight. Recheck tight-
ness of Wheel Weight retaining
Bolts. Bolts should torque to 500
ft. lbs.
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
Rear Wheel Counter Weight
Figure 2
Wheel Weight
Special Washers
Mounting Bolts
Part # 02971569
(3)
Figure 3
Section 7 - 3
Wheel Weight Mntg
Locknuts
Wheel Weight
1400 lbs.