New Holland TS-100A Assembly & Instruction Manual page 59

Optional Lexan RH Door Kit Installation
New Holland "TS" Series Optional Door Kit No. 02980888
5.
Lay the New Lexan Door (P/N 02980803) on a
protected surface (here we used Bubble Wrap Packing
material). Install the push-on weather seal material (P/
N 02980889) with the soft rubber side up as shown. This
weather seal is designed to push-on with out adhesive,
but you can use adhesive if you wanted. Where the two
end meet an adhesive should be used to jion the two end.
Use an adhesve that is rubbery and dries to the touch.
The 3M Co. makes a good Black weather strip adhesive
that will work well for this (See Figure 3)
6.
Install the pipe brace on top of door.( Item 8)
This is the lower fastener (See Figure 4 & 5) and will
need to be installed first, make certain to put the rubber
washer back on fastener, install the fastener untill the
shoulder of the fastener is into the hole in the door. DO
NOT Tighten Fastener at this time.
7.
Install Outer Door Handle and fasteners. (Item
9) This is the outer door handle, before it can be installed
Item 10 must be modified (Item 10) This is the upper
mount of handle rubber pad. There is a shoulder on it that
must be cut off before it can be used, using a sharp knife
cut this shoulder off, The tube Spacer shown with item
3 goes through the hole of item 10 and then slide over
threads of item 9.
8.
Push the lower rubber (with steel insert in it)
into the hole of the door, holding the handle in place fron
the bottom start the bolt & washer item 4, there was a
rubber washer used under item 4 bolt. In some cases
it can not be reinstalled, check bolt engage ment to see
if it can be used.
9
10
Figure 5
Maverick (NH TS-100A,115A , 125A, 135A Asy.Man) 01/05
© 2005 Alamo Group Inc.
4
8
3
Section 6 - 3
Figure 3
8
Figure 4
Figure 6
The two ends
meet here
Inner Latch
Actuater Rod
3
9
4