Table of Contents
Advertisement
SPECIFICATIONS - MAVERICK
READ THIS BEFORE BEGINNING
ASSEMBLY, REPAIRS OR TESTING:
The Maverick has computerized electronics
components can be damaged if care is not taken when performing repairs,
testing and/or during assembly.
DO NOT
DO NOT
1.
short any wires across or allow them to be shorted out.
DO NOT
2.
attempt to jump across any wires or supply them with alternate power
source.
DO NOT
3.
install higher rated fuses than are recommended by manufacturer.
DO NOT
4.
do any welding on unit unless the computer modules are unplugged first, this
is to prevent a power surge going into modules (THIS IS VERY IMPORTANT). This could
also apply to the tractor components. Check Tractors repair guide for specific instruction
about tractor model and type.
DO NOT
5.
attempt to repair or adjust a component that is not intended to be repaired,
example sealed components as there are no serviceable components inside.
DO NOT
6.
let anyone attempt any testing or repairs unless they are an experienced
and qualified technician. Technicians must have proper tools, gauges, meters etc. to
perform proper diagnosis and/or repairs.
DO NOT
7.
perform any repairs with dirty tools or in dirty area. When working on hydraulic
components keeping system clean and free of contamination is important.
DO NOT
8.
start or engage system if the oil level is not at the proper level or condition. Never
start or run unit low or out of oil.
DO NOT
9.
install / add any oil unless you know it is the correct type and the container is
clean. Make certain the oil is not contaminated with dirt or any liquid.
Maverick (NH TS-100A, 115A, 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
Section 1 - 2
. The electronic
Hide quick links:
Advertisement
Table of Contents
