Table of Contents
Advertisement
Exterior Wire Harness Schematic P/N 02981375A
5.
The Return Filter Switch. The return filter
switch is located at the return filter mounted on to the
tank top. The fluid returning from the cylinder control
valve is filtered before returning to tank at this loca-
tion (See Figure 36). The sensor monitors back
pressure created by the filter assembly while cylin-
der circuit is in operation. When the back pressure
reaches 25 psi the switch will trigger and prompt the
operator for a filter element change.
WARNING! This filter does not have a by-
pass. The element must be changed at the appropri-
ate time to avoid element damage and system
contamination.
6.
Oil Cooler & Fan Assembly. The oil cooler /
fan assembly bolts to the tank rail mount bracket
between tractor front axle and hydraulic tank. The
mounting holes are in the tank rail mounting brack-
ets (See Figure 37). There will be two hose con-
nected to the cooler, one from the motod case drain
to the cooler and one from the cooler to the tank
return, These hose will have blue plastic ties on
them.
Maverick (NH TS-100A,115A , 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
FIGURE 36
FIGURE 37
FIGURE 38
Section 8 - 16
Diverter Valve
Diverter Valve Plug
Hide quick links:
Advertisement
Table of Contents
