New Holland TS-100A Assembly & Instruction Manual page 96

Hydraulic Oil Installation 2 WD & 4 WD
Hydraulic Tank Filling:
1.
Filling With Recommended Hydraulic Oil. The oil
used MUST MEET the requirements as to type and
cleanliness level, THIS IS A MUST. The oil must be type
ISO Grade Hydraulic Oil w/ protection wear grade
based on abient temperature (See Decal Figure 4).
The grade of oil will vary with the ambient twmperature.
The Fluid Cleanliness level MUST BE ISO 16/14/11
rating. MAKE CERTAIN that the oil you are using meets
this requirement. If Oil does not test to cleanleness
reguirement, it will have to be filtered to clean it before
installing it into the maverick hydraulic system. NEVER
install or add Oil that does not meet these stadand
requirenments.
2.
Remove the Filler Cap and fill the Hydraulic
Tank, Make certain the oil is ISO AW 100 Hydraulic
Fluid with cleanliness level of ISO 16/14/11 is a must,
however do not over fill or spill oil.
3.
Check that all the hydraulic connections are
complete and tightened on the Motor Hydraulic Sys-
tem and the Cylinder Hydraulic System.
4.
Avoid hydraulic contamination by filtering the hy-
draulic oil while filling the hydraulic tank. Filter buggies
or carts are commercially available for Pre cleaning oil
before it is installed or hydraulic system cleanup. These
consist of a high-efficiency, high-capacity filter, a circu-
lating pump, a drive motor, and hoses for connecting to
oil supply. (See Figure 2 & 3)
When adding hydraulic oil, use only new oil from
a sealed barrel. Used oil or oil from an open barrel may
contain high levels of contamination. Transfer the new
oil into the hydraulic tank by using a hydraulic filter pump
unit equipped with a properly operating micron filter to
achive rquired cleanleness level is a must. This will
insure that the oil being added is safe to use. Do not just
pour the oil directly into the hydraulic tank since most
oils (even from a sealed barrel) have contaminants that
should be removed, before operating the hydraulic sys-
tem. (See Figure 2 & 3).
4.
Important: Change the return filter in tank and
suction filters at recommended hours of operation
(See Operators Manual for maintenace schedule). The only hydraulic oil to be used is the AW
ISOAW Tractor Hydraulic Oil (See Figure 4 for oil Grade ) with a cleanliness level of ISO16/14/
11. Always use a good Filter Maintenance program and Oil cleaning system before adding any oil
to system..
New Holland (NH TS-100A, 115A, 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
Fill
Cap
Figure 1
Figure 2
Figure 3
Section 10 - 2
Sight
Gauge