Table of Contents
Advertisement
Connecting Oil Cooler And Fan As-
sembly to Exterior Wire Harness
1.
Oil Cooler / Fan Assembly. The Oil
cooler / fan assembly is for cooling the oil
being returned from the Motor Case Drain.
The fan is connected to the control box and is
turned on & off automatically. It set to run on a
program that will run the fan in the cooling
rotation for a designated time, then stop, re-
verse the rotation (cycle to clean debris off of
cooler, then stop and reverse the fan again
and begin the cycle all over again.
The connection to the cooler on the
exterior wire harness is marked with code R1.
The connection from the fan will have two
wires, a Blue (+ connection) and a black (-
connection) (See Figure 8).
nection marked R1 connects
FIGURE 8
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
Oil Cooler / Fan Assembly
Exterior wire harness con-
here
Diverter Valve
FIGURE 6
Swivel Cyl. Base End C1 Port (G/W Tie)
From Valve "A"
Port to P1 Diverter
Port (G / WTie)
Valve "A" Port to
P2 Diverter Port
Port (G Tie)
FIGURE 7
FIGURE 9
Section 4 - 8
Swivel Cyl. Rod
End C4 Port (G Tie)
Door Cyl.
Base End
C2 Port
(Y/W Tie)
Door Cyl. Rod End
C3 Port (Y Tie)
Hide quick links:
Advertisement
Table of Contents
