Table of Contents
Advertisement
General Information / Installation Requirements
Lay Out Components in Display
as possible. Lay out the Bolts according to size and length. Lay out the Nuts and washer by size. This
will allow you to see how many of each part as you use them and help to identify any missing parts. (See
figure 6) See Mount Kit Specification and Component Identification Section to help ID Components.
All the component that are received should be check and sorted as to what they are.
Shown below is a general example of the components laid out, this is not a lay out of
the components in this mount kit.
WARNING
DO NOT WELD On This Unit During or After Installation:
DO NOT WELD any components or items on this unit after the installation of the
maverick Boom has begun. The Maverick Boom uses electronic modules and compo-
nents that could be damaged by welding. Before doing any welding ALL ELEC-
TRONIC MODULES AND DISPLAY COMPONENTS MUST BE UNPLUGGED. Check
the Tractors Opertion, Repair, Service or any other manual from the tractor manufac-
turer of the tractor to find any special electronic or special proedures about the tractor
electronics. Taking a few minutes to check could save you from a major damage to
the electronics.
Maverick (NH TS-100A, 115A, 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
. It is helpful to lay out the component in as neat a display
Section 2 - 7
Hide quick links:
Advertisement
Table of Contents
