New Holland TS-100A Assembly & Instruction Manual page 70

6.
Interior Wire Harness (continued). The interior wire harness schematic (See Figure 11 & 12)
shows the wire harness as it is run through the cab. The XS Module will need to be mounted inside the
cab, the best place is behind the RH side panel (See Figure 6, 9 & 12). The wire harness will need it be
put under this panel, also with the connectors in the
appropriate place to connect with the interior components.
The harness to the joys stick will need to be run along the
panel at the back of the cab.
two wires that run under the floor mat, the positive
wire MUST connect to the ignition key switch of the
tractor for a power source. DO NOT Connect the
positive wire anywhere else (See Step 9 & Figure 14
wire CC1).. The plug (G1) will need to run through the floor
to the exterior of the cab, it will connect to the plug (G2) of
the exterior harness. (See figure 11, 12, 13 & 14). Secure
wires under arm rest.
Joystick P/N 02981347
with Resister Harness
FIGURE 12
J1
7.
XS Module P/N 02981533. The XS module
(See Figure 13) mounts in side the tractor cab
behind the right hand side panel (See Figure 13 &
14). The Connections (Three Separate Pugs, Can 1,
Can 2 & D) will be inside the side panel after it is
reinstalled and will not be visible unless you remove
the side panel (See Figure 14 , 16, 17 & 18 ). The XS
Module does not have a mount bracket, it will need to
be mounted by the assembly technician inside
panel where it will be out of the way, not interfere with
any tractor components and be secured. It can be
tied in or bolted. The Only Plugs protruding from
behind RH Interior panel shoud be the plugs for the
display control box (See Figure 14, 16, 17 & 18).
Maverick (NH TS-100A,115A , 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
Joystick / Electrical Mounting
CAUTION: The Harness has
P3
P2
P4
PCB
FIGURE 11
To Activate Trigger Push In
3
6
5
2
4
1
P-1
FIGURE 13
Section 8 - 6
9
8
7
XS Module
P/N 02981533