New Holland TS-100A Assembly & Instruction Manual page 44

Fuel Tank Replacement:
1.
Remove RH Rear Tire and Wheel. Use
proper Floor jack to lift the RH Rear Wheel, Support
the tractor with proper jack stands rated appropri-
ately for the tractors weight. The RH rear tire and
wheel should be removed for this installation by
using a hoist to support and lift the wheel and tire
assembly. The tractors factory fuel tank is mounted
behind the RH rear tire and wheel (See Figure 9).
2.
Remove Tractors Factory Fuel Tank and
Mounting Brackets. The LH factory step will have to
be removed from the tractor before attempting to
remove the fuel tank, the step will not be reused.
The factory fuel tank will need to drained of fuel. Use
an appropriate and safe method for pumping out
tank and for the storage of the fuel removed. The
Tank is removed by loosening and removing the
retaining straps that you will see around the tank
from the out side. DO NOT Attempt to remove tank
with fuel in it.
Store the fuel tank in an appropriate safe place away
from flames, extreme heat and or dusting dirty
conditions. The Fuel Pickup and Gauge sending unit
will need to be removed from the factory tank to be
installed in the new replacement tank later (See
Figure 10).
3.
Install Replacement Fuel Tank Mounting
Brackets. Remove the factory fuel tank mounting
brackets, there are two new mounting brackets that
will be supplied to mount the new tank. There is a
front and a rear bracket (See Figure 11 & 12).
Figure 11
Maverick (NH TS-100A,115A ,125A,135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
Fuel Tank Replacement
Front Fuel Tank
Bracket P/N
02982206
2
Holes
Here
Figure 9
Figure 10
Figure 12
Section 5 - 4
Remove RH
Rear Tire &
Wheel
Rear Fuel Tank
Bracket P/N
02982207
1
Hole
Here