New Holland TS-100A Assembly & Instruction Manual page 75

Exterior Wire Harness Schematic P/N 02981375A
13.
Exterior Wire Harness. The exterior wire harness will run from the cab of the tractor to the front.
It will include the wiring for the sensors at the pump. The connections for the valve actuator assemblies.
The electronic modules that are mounted to the right side of the tank and the module on the front of the
valve. The plugs have codes labeled on them, there is a matching code on them where the plugs are
connected. Some plugs have instructions and/or color codes. Read the next pages of this manual to
become familiar with the wire harness connections. There are two electronic modules bolt on the tank
assembly in the front of the tractor. The XT2 module bolted on the right hand side of the tank and the XP2
bolt on the LH side in front of the 6 spool valve. (See Figure 25, 27 & 28). The exterior wiring harness should
be laid out and connections need to be start at the first connection coming from the tractor cab connection,
this allows the harness to be moved around and under components as needed.
NOTE; V1 Pump Solenoid 2 is only used when the Timbercat Head is installed and will be installed into
plug next to Pump solenoid 1 which is used with all heads. Note: Unless the timbercat head is used only
Solenid 1 will be installed which is Plug V1, leave plug T1 tie to othrer plug out of the way.
Y1 Connect to White Wire & Y2 Connect
to Black Wire ( Valve Filter)
W1 (Charge Filter)
G2 (Plug to Interior
Wire Harness)
R1 (Cooler Fan)
S1 (Temp Sensor)
E (XT2 Module)
FIGURE 25
Plug Valve
Label Function
AA1 Swivel
AA2 Swivel
AA3 Tilt
AA4 Tilt
AA5 Telescope
AA6 Telescope
AA7 Dipper
AA8 Dipper
AA9 Lift
AA10 Lift
AA11 Swing / Door
AA12 Swing / Door
FIGURE 26
NOTE; Decal, Stripes to Base and Solid to Rod end refers to the plastic ties on hoses only &
Maverick (NH TS-100A,115A, 125A, 135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
H1 & H2 ( Lock Valve Connection)
X1 & X2
(Return Filter)
Decal Below shows the Hose location and Plastic tie color on hose.
Valve
Also the markings for the wire harness plugs on valve ("A" or "B")
Label
See Figure 18 & 18A)
B
A
A
B
A
B
A
B
A
B
A
B
not electricl connections
Pump Solenoid
T1 (Sol 2) & V1(Sol1)
Section 8 - 11
BB (Diverter Valve)
AA (See
Below)
F (XP2 Module)