New Holland TS-100A Assembly & Instruction Manual page 22

General Information / Installation Requirements
TRACTOR PREPARATION (FIGURE 1 & 2)
1. Temporally remove ROPS and fenders from tractor axle. Move left rear tire out so that it is 50 inches
from the outside of left rear tire to the center of tractor. Then move the right rear tire out so that it is 96
inches between the outside of the left and right rear tires. Refer to your tractor's Operator's Manual for
instructions on Rear Wheel Adjustment for your particular tire. FIGURE 1. Hydraflate rear left tire as
much as needed for stability but stay in factory-recommend limit.
FIGURE 1
WARNING: Never operate the tractor with a loose wheel rim or disc. Always tighten nuts
to the specified torque and at the recommended intervals.
2. Extend front wheels out so that it is 55" inches between the inside of the tires. This will allow
no interference between tire and front mount bracket. FIGURE 2.
FIGURE 2
Tractor, Area Cleanliness
The Tractor, all tools and work area must be clean of dirt and debris when assembling any hydraulic
components. DO NOT leave any hydraulic component open to the elements. DO not use any containers
for fluids that are not clean and free of any other liquids. DO NOT use rags/cloth that has lint or fuzz on
them when working on hydraulic components. Keep all hoses capped until you are ready to connect
them.
Maverick Cleaning
The Maverick Components are designed to be water resistant. But the sealing can be damaged by
Pressure Washers, Steam Cleaners, Solvents or any other harsh chemical that would be used to clean
the units components. It is important to keep all electrical connections and components sealed and dry.
When washing and cleaning this unit it should be done with a non corrosive soap and low pressure spray
of water. It is recommended that all exposed electronic components be covered and protected from
excess moisture.
Maverick (NH TS-100A,115A ,125A,135A Asy. Man) 01/05
© 2005 Alamo Group Inc.
50"
96"
55"
Section 2 - 6