Engine Cooling System - New Holland WORKMASTER 35 Operator's Manual

Table of Contents

Advertisement

Engine cooling system

Cooling system
WARNING
Hot liquid under pressure!
Scalding can result from fast removal of the radiator cap. Check and service the engine cooling sys-
tem according to the maintenance instructions in this manual.
Failure to comply could result in death or serious injury.
The tractor engine must operate at the correct temperature
to obtain maximum efficiency and service life. This is de-
pendent on the cooling system.
Always fill the system with a 50/50 solution of ethylene gly-
col antifreeze and water.
Checking the coolant level
NOTE: Check the coolant level daily or after every 10 hours
of operation. The engine should be cold when coolant level
is checked.
1. Visually inspect the coolant level in the coolant recov-
ery reservoir (1) the coolant level should be between
the "LOW" and "FULL" lines located on the side of the
reservoir.
2. If the coolant level is not between the "LOW" and
"FULL" lines, add a water/antifreeze solution as neces-
sary. The cooling system already contains antifreeze,
add only antifreeze solution of the correct water/an-
tifreeze mixture. Pure water will dilute the solution and
weaken its protection.
3. Keep the radiator fins clear of chaff or dirt to allow free
air movement.
4. Check and clean front radiator screen (2) every 10
hours of operation.
7 - MAINTENANCE
7-8
W0163A
1
NHIL12CT00679AA
2
NHIL12CT00782AA

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Workmaster 40

Table of Contents