Installing The Main Landing Gear - Seagull Models CLASSIC UGLY STICK Assembly Manual

The propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
INSTALLING THE MAIN
LANDING GEAR.
NOTE : You must now decide if you will
assemble the Classic Ugly Stick with tri-
cycle landing gear or as a tail dragger. If
you are assembling as a tail dragger, please
skip the nose gear installation steps and
mount the main gear to the FORWARD
mounting location. If you are assembling
using the tricycle landing gear, please skip
the tail wheel installation steps, Install the
nose gear, and mount the main gear to the
REAR mounting location.
1) The blind nuts for securing the land-
ing gear are already mounted inside the
fuselage.
2) Using the hardware provided, mount
the main landing gear to the fuselage.
3) Place the fuselage inverted on the work
bench in a suitable stand. Set the landing
gear in place and use a screwdrive to se-
cure the landing gear to the fuselage us-
ing bolts M4x20mm and washers. Make
sure to use the threadlock on the bolts so
they don't vibrate loose.
WWW.SEAGULLMODELS.COM
Collar.
Collar.
15