Hinging The Elevators; Horizontal Stabilizer - Seagull Models CLASSIC UGLY STICK Assembly Manual

WWW.SEAGULLMODELS.COM
Steering arm.
Metal clevis.

HINGING THE ELEVATORS.

Glue the elevator hinges in place using
the same techniques used to hinge the ai-
lerons.

HORIZONTAL STABILIZER.

1) Using a ruler and a pen, locate the center-
line of the horizontal stabilizer, at the trail-
ing edge, and place a mark. Use a triangle
and extend this mark, from back to front,
across the top of the stabilizer. Also extend
this mark down the back of the trailing edge
of the stabilizer.
2) Using a modeling knife, carefully remove
the covering from over the vertical stabilizer
mounting slot in the top of the fuselage.
3) Slide the stabilizer into place in the precut
slot in the rear of the fuselage. The stabilizer
should be pushed firmly against the front of
the slot.
Draw center line
17