Tilt Wire Shelf; Freezer Drawer; Toe Grille; Anti-Tip Leg - Electrolux 5995502399 Service Manual

Tilt Wire Shelf Removal
The freezer tilt wire shelf (located on the inside of the
freezer drawer) is not designed to be removed.

Freezer Drawer

DO NOT remove center screw from freezer drawer.
This is a factory adjustment.
1. Open freezer drawer.
2. Remove drawer screws on right and left sides
(two (2) screws on each side). (See Figure 6-26)
3. When reinstalling, snug drawer screws then turn
another 1/4 turn.
3. Close freezer drawer. The freezer drawer must
mount parallel to the cabinet face. Measure the
distance from the top and bottom of drawer to the
cabinet face, adjust drawer screws until distance is
equal. Check gasket seal around freezer drawer.
Make adjustments on drawer screws if necessary.
Door and Drawer Gasket Removal
The door and drawer gaskets are removed by pulling
the gasket from the channel molded in the unit door or
drawer frame. (See Figure 6-27)
Toe Grille Removal
To remove the toe grille, press the locking tabs on the
bottom of toe grille then lift straight up until the three
clips are free of the spacer screws.
To reassemble:
1. Three clips slide over spacer screws
2. Tabs lock into place in slots on outside edge of the
anti-tip bracket. (See Figure 6-28)
Anti-tip Leg Removal
To remove the anti-tip leg
1. Slightly open freezer drawer and remove toe grille.
2. Rotate anti-tip leg clockwise until it does not contact
the floor.
3. Extract the three bolts securing the anti-tip leg to the
unit frame and remove from unit.
(See Figure 6-29)
Component Teardown
Must Fit In Slot On
Anti-tip Bracket
Spacer Screws
Bolts
6-9
Drawer
Screw
Drawer
Screw
Figure 6-26.
Figure 6-27.

Toe Grille

Figure 6-28.
Figure 6-29.