Freezer Compartment Thermistor; Freezer Compartment Thermistor Removal (Non-Dispenser Models); Freezer Drawer Main Support Rail - Electrolux 5995502399 Service Manual

Component Teardown
Freezer Compartment Thermistor Removal
The freezer compartment temperature sensor is located
on the lower left side of the freezer liner behind a cover
beside the lower basket. (See Figure 6-56)
To replace the sensor:
1. Disconnect power from unit.
2. Open the freezer and remove the lower freezer
basket.
3. Slide screw access cover from thermistor cover.
Extract screw securing thermistor cover to liner.
4. Snap the cover away from the liner.
5. Snap the sensor out of the cover. Disconnect from
the Molex connector plug and replace.
Freezer Compartment Thermistor Removal
(Non-dispenser Models)
The thermister in the freezer has been moved to the
ceiling forward of the LED light housing. Removal is
simular to the side mounted thermistor as described
above.
Upper and Lower Freezer Drawer Rail Removal
To release the freezer basket drawers from the rails
push the release lever as shown and pull drawers from
rails. (See Figure 6-57)
On some models you will need to remove the front trim
for the top two baskets. Remove one screw from each
side of the basket rail going into the trim and pull the trim
straight out. On the lower basket rail assembly there is a
linkage bar between the two gears. Pull the rails out and
expand them enough to remove the bar.
Freezer Drawer Main Support Rail Removal
To remove the freezer drawer main support rail, remove
one screw from main roller assembly and then pull
forward until the three retaining screws heads can pass
through the keyhole slots. (See Figure 6-58)
On the lower basket rail assembly there is a linkage bar
between the two gears. Pull the rails out and expand
them enough to remove the bar.
Screw Access Cover
Left Rail
Screws with
Keyhole Slots
Linkage Bar
6-18
Freezer Compartment
Thermistor Cover
Figure 6-56.
Right Rail
Figure 6-57.
Screw
Figure 6-58.