Door Hinges And Door - Electrolux 5995502399 Service Manual

Door Hinges and Door Removal
1. Disconnect power from unit.
2. Trace lightly around the door's top hinges with a
pencil. This will make reinstallation easier.
3. Disconnect the harness by grasping both sides of
the connector firmly, depress the latch, and pull
apart. Remove the two (2) screws from the top
hinge. Lift the door off of the bottom hinge and set
it aside. (See Figure 6-17 and Figure 6-18)
4. Detach the water tube from the connector located
behind the refrigerator and pull the tube back out to
the front of the unit. The connector releases when
you press inward on the outer sleeve while pushing
the tube toward the connector then while continuing
to hold in the sleeve, pull the tube away.
(See Figure 6-19 and Figure 6-20)
5. Unscrew the three (3) lower hinge screws and hinge
if necessary. (See Figure 6-21)
To reinstall the doors, reverse the above steps.
Once both doors are in place, ensure they are aligned
with each other and level. Replace the top hinge
cover.
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury,
or damage to the doors or handles.
Component Teardown
Front Cover
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
6-7
Rear
Screw
Cover
Screw
Ground
Screw
Top Hinge
Water Line
Figure 6-18.
Figure 6-19.
Press
Press
Water Line
Approximately 3 ft.
Figure 6-20.
Screws
Figure 6-21.