Frame; Control Assembly; Dispenser (Icon) - Electrolux 5995502399 Service Manual

Dispenser
(ICON Models)
Frame Removal
To service the control board you must remove the frame
around the dispenser housing by pulling straight out at a
corner and working your way around the frame, pulling it
out of the groove in the door. (See Figure 6-1)
Control Assembly Removal
1. Remove center trim between the dispenser and
control section. Extract the two screws in the bottom
of the trim. (See Figure 6-5) Pull out the bottom of
the trim and push your hand behind the trim. Push
out on the top of trim with the fi ngers of hand behind
trim.
2. Extract the two screws in the bottom of the control
housing. (See Figure 6-6) Pull the control out at the
bottom till it is clear of the door. Pull straight down
until the two tags at the top are clear of the door.
3. With the control out, disconnect the molex plugs
from the dispenser housing to the control assembly.
This will allow for complete removal of the control.
4. Remove water line from dispenser.
5. Extract the two screws securing the dispenser in the
housing. (See Figure 6-6)
6. Pull dispenser away from housing. Disconnect the
molex plug from the rear of dispenser.
7. To service the control board, disconnect the
electrical lead from the control board.
When handling and or replacing a control board it
is important the a technician have a wrist ground
strap on and connected to the cabinet or another
grounding position to prevent static electricity
from damaging the board.
8. Push back the retaining clips while gently pushing
the control board out from the housing.
(See Figure 6-4)
9. Remove the power supply board from the back of
the control board housing by removing the 4 screws
and disconnecting the wiring harness connector for
the power board to the control.
10. Reinstall in reverse order.
Component Teardown
Remove Screws
Remove Dispenser
6-3
Figure 6-5.
Remove Screws
Screws
Figure 6-6.