Interior Components; Half And Full Spill Safe™ Shelf; Deli Keeper And Crisper; Perfect Temp Drawer - Electrolux 5995502399 Service Manual

Interior Components

Half and Full Spill Safe
™
The shelves have mounting brackets that attach to
slotted supports at the rear of each compartment.
To change the position of a shelf:
1. Before adjusting a shelf, remove all food.
2. Lift the front edge up and pull the shelf out.
(See Figure 6-33)
3. Replace by inserting the mounting bracket hooks
into the desired support slots.
4. Lower the shelf and lock into position.
Deli Keeper and Crisper Removal
Crisper drawers include a sliding control for adjusting
the humidity inside the crisper. This feature can extend
the life of certain fresh vegetables that keep longer in
high humidity.
To remove the crisper drawer:
1. Pull the drawer out until it stops.
2. Lift the front slightly and remove the drawer.
(See Figure 6-34)

Perfect Temp Drawer

™
The power to operate the drawer as well as a wire from
the food compartment light switch, connects to the
control unit by a wire harness coming out through the
liner. This harness will connect to the 4 pin connector in
the bottom right back section of the control unit.
The wiring harness coming from the user interface
control in the cover will connect to a 8 pin connector
located in the top right side toward the front of the
control unit.
The cover over the drawer contains the User Interface
(UI) board and touch control. The NTC thermistor that
senses the drawer temperature is part of the wiring
harness that runs between the user interface and the
main control unit.
To remove the Perfect Temp drawer:
1. Pull the drawer out until it stops.
2. Lift the front slightly and remove the drawer.
(See Figure 6-35)
Shelf Removal
Removal
Component Teardown
6-11
Figure 6-33.
Figure 6-34.
Figure 6-35.