Compressor Area Mounting Tray; Condenser Fan Assembly - Electrolux 5995502399 Service Manual

Component Teardown

Compressor Area Mounting Tray

To access the compressor and inverter, condenser
and fan assembly, or to service the sealed system, it
may require that the compressor area mounting tray be
removed from the bottom of the unit. The mounting tray
is secured with four #2 square bit screws to the bottom
of the unit and two screws to the lower rear corners of
the cabinet.
To remove the compressor area mounting tray:
1. Unplug unit from wall outlet.
2. Pull unit from its installation and block unit up high
enough to access the four bottom screws. Have
on hand blocks to support the mounting tray as the
screws are removed. Several 6 inch pieces of 2" x
4" lumber work well. See Caution Note.
3. Extract the four bottom screws securing the
mounting tray to the rear of the unit.
(See Figure 6-95)
4. Extract the two screws securing the mounting tray to
the rear of the unit.
5. Drop mounting tray down to provide better access
to the grounding screws and sealed system
components.
Condenser Fan Assembly Removal
The condenser fan assembly is secured to the rear of
the compressor area with two bolts to the compressor
mounting plate. The compressor area mounting tray
does not need to be dropped to remove the fan
assembly.
To remove the condenser fan assembly:
1. Pull unit from its installation position and unplug from
wall outlet.
2. Extract the screws securing the compressor shield to
the unit frame and remove from unit.
3. Disconnect wire leads to condenser fan motor at
molex connector.
4. Extract the three bolts securing the fan assembly to
the condenser mounting brackets. (See Figure 6-96)
5. Pull fan motor assembly from unit, then pull fan
blade from motor shaft.
6. Remove the condenser fan shroud by extracting the
two 3/8" bolts securing the shroud to the mounting
tray.
Power Cord
Screw
Compressor Area Mounting Tray
When accessing the compressor area mounting
tray, it is recommended to have two people to block
the unit high enough to access the bottom screws.
The unit is heavy, make sure unit is secure when in
the blocked position. The unit should not rock or
tip when on blocks.
If the unit should tip or fall from the blocks while
extracting the screws, personal injury could occur
and/or damage the unit or the customers personal
property.
If unsure about the safety of this operation, do not
continue. Contact your Regional Service Quality
Manager for assistance.
Electrical
Connection
6-34
Ground
Screws
Bottom Screws
Figure 6-95.
Screws
Figure 6-96.
Inverter
Screw