Operating Cycle Illustrations - Electrical - Electrolux 5995502399 Service Manual

Ice Maker (Freezer Compartment)
Operating Cycle
Illustrations - Electrical
The following wiring diagrams illustrate
the electrical operation of an ice maker.
This procedure is on the Internet at
http://www.frigidaire.com/tip/
.
1 • Ice Maker connected to electricity.
• Mold temperature above 15°F.
• Thermostat open.
• Motor not rotating.
• Mold Heater off.
• Control Arm in the down position.
• Shut-off Switch closed C to NO.
• Hold Switch closed C to NC.
• Water Fill Switch open.
2. • Maker connected to electricity.
• Mold temperature below 15°F.
• Thermostat closes.
• Motor starting.
• Mold heater starting to heat.
• Control Arm in the down position.
• Shut-off Switch closed C to NO.
• Hold Switch closed C to NC.
• Water Fill Switch open.
.
3 • Maker connected to electricity.
• Mold temperature above 15°F.
• Thermostat closes.
• Motor starting to rotate.
• Power on heater.
• Thermostat closed.
• Control Arm in the down position.
• Shut-off Switch closed C to NO.
• Hold Switch closed C to NC.
• Water Fill Switch open.
Figure 4-11.
Figure 4-12.
Figure 4-13.
4-38