Removing The Freezer Drawer - Electrolux 5995502399 Service Manual

Removing The Freezer Drawer

1. Open freezer drawer.
2. Remove drawer screws on right and left sides
(two (2) screws on each side). (See Figure 2-20)
NOTE: DO NOT remove center screw from freezer
drawer. This is a factory adjustment.
3. Lift drawer up and out to remove.
Drawer is heavy. Use caution when lifting.
Installing Freezer Drawer
1. With lower slides pulled out, hang drawer onto slide
brackets ensuring pins on each side are fully insert-
ed into slots on each side. (See Figure 2-21)
2. Reinstall four (4) drawer screws (two (2) per side),
tighten down, and close drawer. (See Figure 2-22)
3. Check gasket seal around top, bottom, and sides of
freezer drawer.
4. If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each side)
to allow drawer to rotate.
5. Close drawer and recheck the seal on the gasket
(A). Open the drawer grabbing by the sides in the
center (B). Be careful not to rotate the drawer.
(See Figure 2-23)
Push Against
Freezer Drawer
Figure 2-23.
Drawer
Assembly
Pin
Grab Drawer
At Center
From Both Sides
Then
Pull Drawer Out
Install Screws
(2) Each Side
2-9
Installation Information
Drawer
Screw
Drawer
Screw
Figure 2-20.
Fully Extend
Drawer Slides
Slot
Figure 2-21.
Figure 2-22.
Cabinet