Evaporator Cover; Ice Maker Air Duct (Non-Dispensing Models) - Electrolux 5995502399 Service Manual

Component Teardown

Ice Maker Air Duct (Non-dispensing Models)

There is an air duct that mounts to the evaporator cover
and directs air onto the icemaker mold. The air duct also
serves as a cover for the icemaker wire harness
connector. The air duct must be removed to disconnect
the icemaker wire harness.
To remove the ice maker air duct:
1. Disconnect refrigerator from electrical supply.
2. Remove the freezer door.
3. Remove freezer section baskets.
4. Extract screw from air duct. Remove air duct from
unit. (See Figure 6-61)
Ice Maker and Mounting Plate
(Non-dispensing Models)
To remove the ice maker:
1. Disconnect refrigerator from electrical supply.
2. Remove the freezer door.
3. Remove freezer section baskets.
4. Remove icemaker air duct.
5. Disconnect icemaker from wire harness connection.
6. Extract the one screw at the front of mounting plate.
(See Figure 6-62)
7. The icemaker will then slide forward to allow the
shoulder screws in the liner to pass through the key-
hole slots in the mounting plate.
8. The mounting plate is removed from the icemaker by
extracting the three screws from the bottom of the
assembly. (See Figure 6-63)
Screw
6-20
Figure 6-61.
Screws
Figure 6-62.
Keyhole Slots
Screws
Figure 6-63.