Table of Contents
Advertisement
4 - Operating your appliance
How to use the features of your
appliance
This section tells you how to make the most of the
appliances many useful features and how to clean them.
Door storage bins (shelves)
The all refrigerator is fitted with door storage bins. You
can adjust these bins to meet different storage needs. All
the door bins are completely removable for cleaning. If
you want to remove or adjust a bin, lift it over the support
lugs on the inner door panel. Push the bin down over the
support lugs to lock it in place.
Dairy compartment
You can use the Dairy compartment to store foods such as
butter, margarine and cheeses. The compartment is slightly
warmer than the rest of the refrigerator compartment.
Crisper Bin
Storing vegetables
You
can
use
the
crisper bin to store
vegetables,
fruit
or
smallgoods. You can
change the humidity
inside
the
bin
by
rotating the humidity
control.
You should store vegetables in the crisper bin remembering
to set the humidity control to more humid.
Storing fruit & smallgoods
You can also store fruit & smallgoods in the crisper bin
remembering to set the humidity control to less humid.
Crisper Bin and shelf removal
• Remove the crisper bin(s) by pulling forward, then
up and forward.
• Remove the glass (if fitted) by flexing the rear of the
shelf backward to disengage the clip and allowing the
glass to drop out of the plastic frame.
• Remove the crisper shelf by lifting the catches on the
underside of the shelf and pulling the shelf forward.
Sliding Deli Shelf/ Bin (where fitted)
The sliding deli bin allows you to position the deli-bin
in any position within the appliance. This allows you to
conveniently locate it around stored food or to align it with
the multi flow vents for direct cooling.
Usage Instructions:
In order to correctly use the deli bin it should be located
fully on the left or right or in a central position. This will
align the multiflow vents with the ducting surfaces at
the rear of the deli bin. One or both of the vents can be
opened to allow cooler air to pass over foodstuffs stored
in the deli.
The air from these vents can be very cold, which is useful
for the fast chilling of food and drinks. However, items
may freeze if left near the vents. To prevent freezing, move
items away from the vents after chilling.
Cleaning: The sliding deli shelf can be removed for ease
of cleaning. In order to do so a flexible locking mechanism
has been incorporated into the rear shelf rail.
• Remove Deli Bin
• Remove the shelf assembly
by pulling it past the stops.
• Place the full assembly up
side down on a flat surface.
• Slide the sub frame to the left until it engages with
the locking mechanism.
• Pull the thumb tag away from the
rail to disengage it.
• Slide the sub frame past this and
allow it to flex back into position.
Clean the parts as required and allow to
dry. To replace the sub frame repeat this
procedure making sure to align the front
lip on the front shelf recess.
ALL GLASS USED IS SAFETY GLASS.
HOWEVER CAUTION SHOULD BE
TAKEN WHEN REMOVING THE
SHELF FOR REPOSITIONING OR FOR
CLEANING. AS THE ASSEMBLY IS
RELATIVELY HEAVY AND IF HELD IN
THE VERTICAL POSITION (AS SHOWN)
THE RUNNER ASSEMBLY MAY DROP
DOWN.
DO NOT REMOVE ANY SCREWS!
Page 9
Advertisement
Table of Contents
