Siemens siprotec 7SA6 User Manual page 506

Control During Operation
:
From PC with
®
DIGSI 4
7-22
0HDVXUHPHQW

!6HW 3RLQWV 09
5HVHW
3: 6HWWLQJV"

$UH \RX VXUH"
!<HV 1R (VFDSH
Figure 7-23 Setting of set-points on the device front — example
With the keys and
To change a set point, it must be marked using the keys
key.
ENTER
A prompt for the entry of password No. 5 (for individual settings) appears. After entry
of the password and confirmation with
a flashing cursor. The current value must be overwritten with the desired new value
using the numeric keys. If the permissible range for the setting value is exceeded to
the top or the bottom, the maximum or minimum set point value appears at the bottom
of the display when the value is entered.
Press the ENTER key. The new value now appears in the list of set points.
In the same way, further set points, if available, can be modified.
If this level is exited with the key
default answer "<HV" appears (Figure 7-23). Confirm with the key
the value. If the value must not be modified, press the
is marked, and confirm with the
mark "$ERUW", confirm with the
Set points are only available in online–mode. The metered value groups are to be
found under 0HDVXUHPHQW (Figure 7-2) by double-clicking on the latter. Select 2WKHU
and then 6HW 3RLQWV 0HDVXUHG 9DOXHV Figure 7-24).
By double clicking on an entry in the list in the right part of the window, the set points
are loaded. Mark the number of the value which is to be changed. With a right mouse
click, open the context menu and click on 6HW, as shown in Figure 7-24. A password
inquiry (password No 5 for individual settings) occurs. Next, the dialog field 6HW
0HWHUHG 9DOXH is opened. Enter the desired value in the entry field. Then click on
2..
The entered value is transferred to the device and the display within the window in
Figure 7-24 is updated.


6(7 32,176 09 


,/ /LPLW
,/ /LPLW
Enter password Nr. 5 (for individual
ENTER
parameters) and confirm with
,/ /LPLW
ENTER
the user can page up and down in the set point table.
, the current value appears in a frame with
ENTER
the query "$UH \RX VXUH"", with the
or
MENU
key. If the value is to be modified once more,
ENTER
ENTER key and enter the value again.
 $
 $
etc.
ENTER

ENTER
and . Then press the
, to validate the
ENTER
key, so that the answer "1R"
7SA6 Manual
C53000-G1176-C133-1