User Interface; Operation Using The Operator Control Panel - Siemens siprotec 7SA6 User Manual

3.3

User Interface

3.3.1

Operation Using the Operator Control Panel

Operator Control
Panel
Reading Ordering
Number/Version
7SA6 Manual
C53000-G1176-C133-1
The device has a hierarchically structured operating tree, within which movements
and actions are made using the
keys on the front panel.
The brief discussions below illustrate the navigation techniques using the integrated
operations in the operator control panel. Some typical operations are covered. For
easier understanding, the accompanying figures show the entire contents of the
menus, while only a limited number of lines can be seen in the display at any time.
To view the complete ordering number of the device, the version of firmware
implemented, and the serial number:
q
When the device is ready for operation, first press the
appears.
q
key, select the menu item 6HWWLQJV, and move to the device settings
Using the
key. The 6(77,1*6 menu appears, as shown in Figure 3-1.
using the
q
key, select the menu item 6HWXS([WUDV and switch to the selection
Using the
6(783(;75$6 using the
0$,1 0(18

$QQXQFLDWLRQ
0HDVXUHPHQW
&RQWURO
!6HWWLQJV
7HVW'LDJQRVH ²!
Main menu and sub-menu 6(77,1*6
Figure 3-1
q
key, select the menu 0/)%9HUVLRQ and view the selection 0/)%
Using the
9(56,21 using the
The device-specific data appear in two or three lines. Press the
to view all of the data:
, , , keys and the
key. See Figure 3-2.

²! 
²! 
²! 
²! 

key.
Initial Inspections
, ,
MENU ENTER CTRL
key. The 0$,1 0(18
MENU
6(77,1*6 

'HYLFH &RQILJ ²! 
0DVNLQJ ,2 ²! 
36\VWHP 'DWD ²! 
*URXS $ ²! 
*URXS % ²! 
*URXS & ²! 
*URXS ' ²! 
&KDQJH *URXS ²! 
2VF)DXOW 5HF ²! 
!6HWXS([WUDV ²! 
'HYLFH ²! 
key as necessary
and
ESC
3-5