802.1X With Acl Assignment Configuration Example - HP 5120 EI Switch Series Configuration Manual

802.1X with ACL assignment configuration example

Network requirements
As shown in
access device.
Perform 802.1X authentication on the port. Use the RADIUS server at 10.1.1.1 as the authentication and
authorization server and the RADIUS server at 10.1.1.2 as the accounting server. Assign an ACL to
GigabitEthernet 1/0/1 to deny 802.1X users to access the FTP server.
Figure 35 Network diagram for ACL assignment
192.168.1.1/24
Host
192.168.1.10
NOTE:
The following configuration procedure provides the major AAA and RADIUS configuration on the
access device. The configuration procedures on the 802.1X client and RADIUS server are beyond the
scope of this configuration example. For information about AAA and RADIUS configuration
commands, see the
Configuration procedure
Configure 802.1X client. Make sure the client is able to update its IP address after the access port
1.
is assigned to the 802.1X guest VLAN or a server-assigned VLAN. (Details not shown)
Configure the RADIUS servers, user accounts, and authorization ACL, ACL 3000 in this example.
2.
(Details not shown)
Configure the access device.
3.
# Assign IP addresses to interfaces. (Details not shown)
# Configure the RADIUS scheme.
<Device> system-view
[Device] radius scheme 2000
[Device-radius-2000] primary authentication 10.1.1.1 1812
[Device-radius-2000] primary accounting 10.1.1.2 1813
[Device-radius-2000] key authentication abc
[Device-radius-2000] key accounting abc
[Device-radius-2000] user-name-format without-domain
[Device-radius-2000] quit
# Create an ISP domain and specify the RADIUS scheme 2000 as the default AAA schemes for the
domain.
Figure 35, the host at 192.168.1.10 connects to port GigabitEthernet 1/0/1 of the network
Authentication servers
(RADIUS server cluster)
10.1.1.1/10.1.1.2
GE1/0/2
GE1/0/3
GE1/0/1
Vlan-int2
Device
Security Command Reference
Internet
FTP server
10.0.0.1
.
89