Triple Authentication Configuration Examples; Triple Authentication Basic Function Configuration Example - HP 5120 EI Switch Series Configuration Manual

To do...
Configure MAC
authentication
Configure Layer-2 portal
authentication
NOTE:
802.1X authentication must use MAC-based access control.

Triple authentication configuration examples

Triple authentication basic function configuration example

Network requirements
As shown in
configure triple authentication on the Layer-2 interface of the switch that connects to the terminals, so that
a terminal passing one of the three authentication methods, 802.1X authentication, portal authentication,
and MAC authentication, can access the IP network. More specifically,
 Configure static IP addresses in network 192.168.1.0/24 for the terminals.
 Use the remote RADIUS server to perform authentication, authorization, and accounting and
configure the switch to send usernames carrying no ISP domain names to the RADIUS server.
The local portal authentication server on the switch uses listening IP address 4.4.4.4. The switch

sends a default authentication page to the web user and forwards authentication data using HTTP.
Figure 45 Network diagram for triple authentication basic configuration
802.1X client
Printer
Web user
Configuration procedure
Use the command...
See the chapter ―MAC authentication
configuration‖
See the chapter ―Portal configuration‖
Figure 45, the terminals are connected to a switch to access the IP network. It is required to
Vlan-int8
192.168.1.1/24
GE1/0/1
RADIUS server
1.1.1.2/24
Vlan-int1
1.1.1.1
Switch
Vlan-int3
3.3.3.1
132
Remarks
Configure at least one type of
authentication.
IP network