Configuring Port Security Features; Configuring Ntk - HP 5120 EI Switch Series Configuration Manual

To do...
Enter Layer 2 Ethernet
interface view
Set the port security mode
NOTE:

When a port operates in autoLearn mode, the maximum number of secure MAC addresses cannot be changed.

An OUI, as defined by the IEEE, is the first 24 bits of the MAC address, which uniquely identifies a device
vendor.

You can configure multiple OUI values. However, a port in userLoginWithOUI mode allows only one 802.1X user
and one user whose MAC address contains a specified OUI to pass authentication at the same time.

After enabling port security, you can change the port security mode of a port only when the port is operating in
noRestrictions mode, the default mode. To change the port security mode for a port in any other mode, use the
undo port-security port-mode command to restore the default port security mode first.

Configuring port security features

Configuring NTK

The NTK feature checks the destination MAC addresses in outbound frames to make sure that frames are
forwarded only to authenticated devices. Any unicast frame with an unknown destination MAC address is
discarded.
The NTK feature supports the following modes:
ntkonly—Forwards only unicast frames with authenticated destination MAC addresses.

ntk-withbroadcasts—Forwards only broadcast frames and unicast frames with authenticated

destination MAC addresses.
ntk-withmulticasts—Forwards only broadcast frames, multicast frames, and unicast frames with

authenticated destination MAC addresses.
Follow these steps to configure the NTK feature:
To do...
Enter system view
Enter Layer 2 Ethernet interface
view
Use the command...
interface interface-type interface-
number
port-security port-mode { autolearn |
mac-authentication | mac-else-
userlogin-secure | mac-else-
userlogin-secure-ext | secure |
userlogin | userlogin-secure |
userlogin-secure-ext | userlogin-
secure-or-mac | userlogin-secure-or-
mac-ext | userlogin-withoui }
Use the command...
system-view
interface interface-type interface-
number
146
Remarks
—
Required
By default, a port operates in
noRestrictions mode.
Remarks
—
—