Configuring A User Profile; Enabling A User Profile - HP 5120 EI Switch Series Configuration Manual

To do...
Enter system view
Create a user profile, and enter its
view

Configuring a user profile

After a user profile is created, apply a QoS policy in user profile view to implement restrictions on online
users. The QoS policy takes effect when the user profile is enabled and a user using the user profile goes
online.
Follow these steps to configure user profile:
To do...
Enter system view
Enter user profile view
Apply the QoS policy
NOTE:

If a user profile is enabled but not used by any online user, you can edit only the content of the ACL that is
referenced by the QoS policy in the profile. If the user profile is being used by online users, you cannot edit any
configuration in the QoS policy.

The QoS policies that can be applied to user profiles support only the remark, car, and filter actions.

Do not apply an empty policy in user profile view because a user profile with an empty policy applied cannot be
enabled.

Enabling a user profile

Enable a user profile so that configurations in the profile can be applied by the device to restrict user
behaviors. If the device detects that the user profile is disabled, the device denies the associated user
even the user has been verified by the authentication server.
Follow these steps to enable a user profile:
To do...
Enter system view
Enable a user profile
Use the command...
system-view
user-profile profile-name
Use the command...
system-view
user-profile profile-name
qos apply policy policy-name
{ inbound | outbound }
Use the command...
system-view
user-profile profile-name enable
162
Remarks
—
Required
You can use the command to
enter the view of an existing user
profile.
Remarks
—
Required
Required
The inbound keyword applies the QoS policy to
incoming traffic of the switch (traffic sent by
online users). The outbound keyword applies the
QoS policy to outgoing traffic of the switch
(traffic sent to online users).
Remarks
—
Required
A user profile is disabled by
default.