Radius Authentication And Authorization For Telnet Users By A Network Device - HP 5120 EI Switch Series Configuration Manual

Connected to 192.168.1.70 ...
******************************************************************************
* Copyright (c) 2010-2011 Hewlett-Packard Development Company, L.P.
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
******************************************************************************
Login authentication
Username:test@bbb
Password:
<Switch> ?
User view commands:
cluster
display
ping
quit
ssh2
super
telnet
tracert
When switching to user privilege level 3, the Telnet user only needs to enter password enabpass as
prompted.
<Switch> super 3
Password:
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
If the HWTACACS server is not available, the Telnet user needs to enter password 654321 as prompted
for local authentication.
<Switch> super 3
Password:  Enter the password for HWTACACS privilege level switch authentication
Error: Invalid configuration or no response from the authentication server.
Info: Change authentication mode to local.
Password:  Enter the password for local privilege level switch authentication
User privilege level is 3, and only those commands can be used
whose level is equal or less than this.
Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE
RADIUS authentication and authorization for Telnet users by a
network device
Network requirements
As shown in
authorization for the Telnet user on port 1645.
Run cluster command
Display current system information
Ping function
Exit from current command view
Establish a secure shell client connection
Set the current user priority level
Establish one TELNET connection
Trace route function
Figure 22, configure Switch B to act as a RADIUS server to provide authentication and
59
*
*
*