HP 5120 EI Switch Series Configuration Manual page 45

To do...
Enter HWTACACS scheme
view
Specify a source IP address
for outgoing HWTACACS
packets
Setting timers for controlling communication with HWTACACS servers
Follow these steps to set timers regarding HWTACACS servers:
To do...
Enter system view
Enter HWTACACS scheme view
Set the HWTACACS server
response timeout timer
Set the quiet timer for the primary
server
Set the real-time accounting
interval
NOTE:

For real-time accounting, a NAS must transmit the accounting information of online users to the HWTACACS
accounting server periodically. If the device does not receive any response to the information, it does not forcibly
disconnect the online users.

The real-time accounting interval must be a multiple of 3.

The setting of the real-time accounting interval somewhat depends on the performance of the NAS and the
HWTACACS server. A shorter interval requires higher performance.
Displaying and maintaining HWTACACS
To do...
Display configuration information or
statistics of HWTACACS schemes
Display information about buffered
stop-accounting requests that get no
responses
Clear HWTACACS statistics
Use the command...
hwtacacs scheme hwtacacs-
scheme-name
nas-ip ip-address
Use the command...
system-view
hwtacacs scheme hwtacacs-
scheme-name
timer response-timeout seconds
timer quiet minutes
timer realtime-accounting minutes
Use the command...
display hwtacacs [ hwtacacs-server-
name [ statistics ] ] [ slot slot-number ] [
| { begin | exclude | include } regular-
expression ]
display stop-accounting-buffer
hwtacacs-scheme hwtacacs-scheme-
name [ slot slot-number ] [ | { begin |
exclude | include } regular-expression ]
reset hwtacacs statistics { accounting |
all | authentication | authorization } [
slot slot-number ]
35
Remarks
—
Required
By default, the IP address of the outbound
interface is used as the source IP address.
Remarks
—
—
Optional
5 seconds by default
Optional
5 minutes by default
Optional
12 minutes by default
Remarks
Available in any view
Available in any view
Available in user view