Table of Contents
Advertisement
2.2 Securing the Device
Regardless of the mounting method of the
use a stipulated safety wire. Swipe it through one of the two handles of the
fixture and connect it to the primary support structure. Pay attention to a safe
and proper fastening. The safety cable must comply with BGI 810-3 (EN 60598-
2-17 Section 17.6.6) and be capable of bearing a static suspended load that is
ten times the weight of the fixture and all installed accessories.
2.3 Connections
2.3.1 Power Supply
~100-240 Volt AC, 50-60 Hz, earth contact type plug, via Powercon
Connected load 400 VA (W) <=> T5A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.
2.3.2 NEUTRIK powerCON
The
V
V
conductor AC connectors. Up to max. 11 fixtures can be linked via the
power outlets staying within the power limits of the 20A of the
connectors.
Note: Regional regulations and
limits might be lower and differ
from that.
GLP
German Light Products GmbH
O
L
K
S
L
I
C
H
T
S
P
O
O
L
K
S
L
I
C
H
T
S
P
O
V
O
L
K
V
O
L
K
T is fitted with NEUTRIK powerCON locking 3
T
blue
Picture: Courtesy of NEUTRIK AG
(Instruction version 1.01) / from software version 1.07
S
L
I
C
H
T
S
P
O
T you'll have to
S
L
I
C
H
T
S
P
O
T
grey
8
Advertisement
Table of Contents
