Securing The Device; Connections; Power Supply; Dmx - GLP Volks Licht R-G-B Instruction Manual

two truss belts. Never use the "Mounting in hanging position" technique
described above to secure the fixture in a sideway position, as the
fixtures base can become damaged, and a secure installation cannot be
assured.

2.2 Securing the Device

Regardless of the mounting method of the
secondary safety wire. This safety wire can be attached to the fixture by
threading it through one of the two holes provided on the base of the fixture.
Ensure that the safety wire is securely fastened through the fixture and the
fixtures mounting support. Install a safety wire that can hold at least 10 times
the weight of the fixture.

2.3 Connections

2.3.1 Power Supply

~100-240 Volt AC, 50-60 Hz, earth contact type plug, via Powercon
Connected load 180 VA (W) <=> T2A (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use
only the above described micro-fuse type.

2.3.2 DMX

USITT DMX-512 Standard input/output in 3 pole connectors.
3 pole: Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
The DMX- Addressing starts at the DMX- Address [001].
GLP German Light Products GmbH
R - G - B
R - G - B
R - G - B
V
V
(Instruction version 1.7) / from software version 1..15)
O L K S L I C H T you'll have to use a
O L K S L I C H T
8