Table of Contents
Advertisement
TROUBLESHOOTING
Before asking for repairs, please check the following symptoms.
If the solutions below do not solve the problem or the symptom is not listed below, ask at the shop where you purchased
the appliances.
Symptom
The power cord insulation
is damaged.
The power cord,
connectors or the power
plug are hot during use.
The power cord gets warm
or hot if bent or pulled
during use.
Power is not supplied.
The encoder/decoder
does not start up normally
after turning the power on.
The OPERATE indicator is
blinking (BLINKING
TEMPERATURE WARNING).
80
Possible cause / Possible solution
• The power cord, connectors or the power plug are
damaged.
If you continue to use it, a fire or an electric shock
may occur.
Unplug the power plug immediately, and refer
servicing of the plug to qualified service personnel.
• Is the power cord connected correctly?
Is the power plug firmly plugged into an outlet?
Insert the power plug firmly into an outlet.
• Are the dip switches on the front panel set correctly?
Set the dip switches on the front panel correctly.
Be sure to set unused dip switches to OFF.
• It is possible that an IP address has not been
assigned from the DHCP server even if the DHCP
server is used.
Confirm that the DHCP server is running correctly.
• When the decoder is restarted while receiving
streaming video by the unicast transmission, it may
take more than 10 minutes for the decoder to
display streaming video.
• The temperature inside the encoder/decoder is
beyond the specified temperature.
Are the ventilation openings or the cooling fan slots
blocked by dust, etc.?
In this case, remove dust around the ventilation
openings or the cooling fan slots.
When the OPERATE indicator still blinks after
turning off the power and leaving the unit for a while,
a malfunction of the cooling fan may have occurred.
Refer to your dealer.
Reference page
–
10, 13
–
22
27
Advertisement
Table of Contents
