Table of Contents
Advertisement
SETTINGS MENUS OF THE DECODER
USER page
Perform the setting to restrict users to access the
decoder on this page.
It is possible to restrict access to the decoder by the
"USER RESTRICTION" and the "HOST
AUTHENTICATION".
Refer to the next page when using both the "USER
RESTRICTION" and the "HOST AUTHENTICATION".
Notes
• The following user (administrator) is registered as
default setting.
USER NAME: admin
PASSWORD: none (blank)
ACCESS LEVEL: 1 (ADMINISTRATOR)
• It is impossible to delete the user "admin".
It is possible to set a password for the user "admin".
However, if the entered password is forgotten, it is
necessary to reset all the settings to the default
settings by setting the "SW2" switch on the front
panel of the encoder to "ON".
When the password is entered, write it down and
keep it safely so as not to forget it.
• Click the [SET] button to save the changed settings.
Otherwise, the changed settings will not be saved.
76
■ Item Descriptions
● USER AUTHENTICATION
Select "ON" or "OFF" to set whether to apply the
user authentication or not.
However, when using a web browser to perform the
settings, it is necessary to be authenticated
regardless of the "ON" or "OFF" setting.
The default setting is "OFF".
● SETUP
Up to 16 users can be registered.
A registered user can be deleted using the
"DELETE" pull-down menu in the section at the
bottom of this page.
USER NAME/PASSWORD
Enter up to 16 alphanumeric characters for the user
name and the password.
However, the colon (:) and the semicolon (;) cannot
be used.
PASSWORD (TWICE)
Enter the password again for confirmation.
ACCESS LEVEL
Select one of the following for the access level.
1 (ADMINISTRATOR)
It is possible to perform the settings on the settings
pages and operate the decoder using the CGI
commands.
2 (CONTROL)
It is possible only to operate the decoder using the
CGI commands. It is not possible to perform the
settings on the settings pages.
Note: The monitor control is performed by the CGI
command. It is possible to select whether to
display 4 streams on a single screen (QUAD) or
to display one of the 4 streams (CH1 - CH4) on a
monitor. (Refer to page 107.)
[ADD] button
Click to add a user after entering the user
information.
● DELETE
Select a user to be deleted from the pull-down menu,
and click the [DELETE] button.
Confirm that the user has been deleted from the pull-
down menu.
Note: To set the password for the default user
"admin", enter "admin" in the "USER NAME"
input box, and the password in the "PASSWORD"
and "PASSWORD (TWICE)" input boxes.
The access level setting will be fixed to "1
(ADMINISTRATOR)".
Advertisement
Table of Contents
