Table of Contents
Advertisement
Description Labels
The description labels and the code labels are provided as standard accessories of the encoder and the decoder
respectively.
Attach each label on the top of the appliances as described below according to needs.
Labels for Encoder
• Description label (1)
There are descriptions about the "SW2" and the
"STATUS" indicators (STATUS 1 - 8) on this label.
Attach this label to the top front side of the encoder
(shown in the illustration on the right), on the container
box or on the rack.
• Description label (2)
There are descriptions about the layout of the
connectors on the rear panel and the indicators of the
Ethernet port (100BASE-TX) on this label. Attach this
label to the top rear side of the encoder (shown in the
illustration on the right), on the container box or on the
rack.
• Code label
The MAC address of the appliance is described on this label. Keep this label by attaching it to the provided CD-ROM
case, etc. The MAC address is also described on the label attached inside the front panel cover.
Labels for Decoder
• Description label
There are descriptions about the "SW2" and the
"STATUS" indicators (STATUS 1 - 8) on this label.
Attach this label to the top front side of the decoder
(shown in the illustration on the right) or on the rack.
• Code label
The MAC address of the appliance is described on this
label. Keep this label by attaching it to the provided CD-
ROM case, etc. The MAC address is also described on
the label attached on the rear panel.
Description label on the top (2)
Description label on the top (1)
Description label on the top
31
Advertisement
Table of Contents
